Stihl BT 360, Инструкция по эксплуатации

Страница: 10 / 28

BT 360
English
8
N
Position the hinge plates (11) of the
handlebars (10) against the hinge
plates (2) on the inner sections (1)
and line up the holes.
N
Place the hex head screws (8) with
retainer (9) in position.
N
Insert the hex head screws (8) and
tighten them down firmly.
If throttle lever is not preassembled
N
Fit the washer (12), lever (13) and
washer (14) on the guide (15) as
shown.
N
Fit the cap (16), making sure its two
stop lugs (arrows) engage the stop
lugs (arrows) on both sides of the
guide (15).
N
Insert the M6x55 countersunk
screw through the cap (16), washer
(14), lever (13), washer (12) and
guide (15).
N
Fit the washer (18) – it holds the
preassembled throttle lever
together.
Mounting the Throttle Lever
N
Insert countersunk screw (17) with
preassembled throttle lever through
the hole in the handlebar (10).
N
Fit the washer (19).
N
Screw on the nut (20) and tighten it
down firmly – the throttle lever (13)
must move freely.
Fitting the Throttle Cable
Use only the throttle cable supplied with
the machine.
N
Push the throttle cable – small
nipple first – through the opening.
N
Slip the spring (21) over the small
nipple (22) on the throttle cable.
N
Attach nipple (22) to the lever (23)
on the carburetor.
N
Push spring (21) against the lever
(23) – fit the throttle cable in the
retainer (24) and push the throttle
cable's end sleeve (25) into the
retainer (24) as far as stop.
2
11
10
9 11 2 8 8 9
441BA051 KN
1
13
12
15
14
16
441BA038 KN
18
13 17
10
441BA052 KN
19
20
441BA053 KN
24
22
21
25
441BA040 KN
23