Stihl BT 360, Инструкция по эксплуатации

Страница: 14 / 28

BT 360
English
12
Starting the Engine
WARNING
To reduce the risk of serious accidents
and injury never start the engine with the
auger in the spindle.
N
Place the machine on the ground so
that it rests on the handle frame with
the throttle lever at the top. Both
operators must hold the handlebar
steady and secure it by putting one
foot through each end of the
handlebar and pressing down.
N
Observe safety precautions – see
chapter on "Safety Precautions and
Working Techniques".
N
Pull the choke knob (1) out if the
engine is cold. Push the choke knob
(1) inif the engine is warm(also use
this position if engine has been
running but is still cold).
N
Move the stop switch (2) away from
"STOP".
N
Move the stop switch (3) to
F
.
N
Turn the throttle lever (4) with your
left hand until it is in line with the
handlebar (starting throttle
position).
Cranking
N
Pull the starter grip slowly with your
right hand until you feel it engage
and then give it a brisk strong pull.
Do not pull out the starter rope to full
length – it might otherwise break.
N
Do not let the starter grip snap back.
Guide it slowly back into the housing
so that the starter rope can rewind
properly.
If the engine is new, pull the starter rope
several times to prime the fuel system.
Starting / Stopping the
Engine
441BA047 KN
441BA059 KN
1
441BA060 KN
2
3
441BA061 KN
441BA062 KN
441BA063 KN