Stihl BT 360, Инструкция по эксплуатации

Страница: 11 / 28

BT 360
English
9
N
Fit throttle cable nipple (26) in the
recess (27) on the underside of the
throttle lever.
N
Position the throttle cable in the
guide (arrows).
N
Push the end sleeve (28) into its
seat (29) in the throttle lever.
N
Secure the throttle cable (30) to the
handlebar with two cable ties,
a = 70 mm and b = 320 mm – the
throttle cable should be on the
inside of the handlebar.
Checking Operation of Throttle Lever
1. Operate the throttle lever.
2. Release the throttle lever – it must
return automatically to idle position.
Mounting Stop Switch on Handlebar
N
Position stop switch (32) against
handlebar.
N
Fit the clamp (33).
N
Insert the screws (34) and tighten
them down firmly.
N
Secure wiring harness to the
handlebar with three cable ties (35),
a = 60 mm, b = 300 mm and
c = 60 mm – wiring harness should
be on inside of the handlebar.
Preparing Machine for Transportation
N
Loosen and remove the lower hex
head screws on the hinge plates at
the throttle cable side and the upper
hex head screws on the hinge
plates at the other side.
N
Loosen the other hex head screws
on the hinge plates (about 1/2 turn).
N
Fold the handlebar at the throttle
cable side upwards, and the
handlebar at the other side
downwards – take care not to kink
the throttle cable.
All hex head screws on the hinges must
be tightened down firmly after unfolding
the handlebars.
26
28
441BA054 KN
29
b
a
30
31
31
441BA055 KN
441BA043 KN
2.
1.
441BA056 KN
32
33
34
35
a
441BA057 KN
b
c
441BA058 KN