Stiga E 300 Li 20 A, Руководство оператора, Страница: 32 / 42

EN - 5
6.1.3 Cutting height adjustment (Fig.20 ÷21 )
6.1.4 Handle height/inclination adjustment ( Fig.15)
6.2 SAFETY CHECKS
Always carry out the safety checks before use.
6.2.1 General safety check
Object Result
Grips Clean, dry.
Handle Fixed firmly to the machine.
Blade Clean, not damaged or
worn, well sharpened.
Rear discharge guard;
grass catcher
Good condition. No
damage. Properly installed.
Replace if damaged.
Switch command The lever must move
freely, it must not need
forcing and should
return automatically
and rapidly back to
the neutral position.
Battery
No damage to the casing,
no liquid leakage.
Screws/nuts on the
machine and on the
cutting blade
Correctly tightened
(not loose). Not
damaged or worn.
Cooling air ducts Not clogged
Machine No signs of damage
or wear. No abnormal
vibrations. No
abnormal sound.
Action Result
1. Start the machine (par.
6.3).
2. Release the switch
control (Fig.28).
1. The blade should
move.
2. The lever should
automatically and
quickly return to
neutral position, the
engine must switch
off and the blade
must stop within
a few seconds.
If any of the results fail to match the indications
provided in the tables, do not use the machine! Contact
an authorised service dealer to have it checked and
repaired if necessary.
6.3 START-UP (Fig.22
-
25)
NOTE Start up the machine on a flat surface
without obstacles or high grass.
Start of the motor simultaneously engages the
cutting blade.
6.4 OPERATION (Fig.26)
IMPORTANT If the motor stops because
it is overheated whilst mowing, you must wait
approximately 5 minutes before restarting it.
6.4.1 Grass cutting (Fig.27)
NOTE Regulate the forward speed and the
cutting height considering the conditions of the
lawn (the height, density and dampness of the
grass) and the amount of grass collected.
6.4.2 Emptying the grass catcher (Fig.28
-
29)
6.5 STOP (Fig.28)
When you have stopped the machine,
it will take a few seconds for the cutting
blade to stop.
IMPORTANT | Always stop the machine:
• When moving between work areas.
• When driving on grass free surfaces.
• Every time it is necessary to overcome an obstacle.
• Before adjusting the cutting height.
• Whenever you remove or reattach the grass catcher.
6.6 AFTER USE
1.
Open the hatch and remove the safety key.
2. Remove the battery from its housing
and recharge it (par 7.2.3).
3. Allow the engine to cool before
storing in an enclosed space.
4. Clean (par. 7.3).
5. Make sure there are no loose or damaged
components. If necessary, replace the damaged
components and tighten any screws and loose
bolts or contact the authorised service dealer.
6. Check there are no damages to the machine. If
necessary contact the authorised service dealer.
IMPORTANT Remove the safety key whenever
the machine is unused or left unattended.