Steca TF B001, Инструкция по установке и эксплуатации

Страница: 9 / 24

9
745.089 | 11.30
EN
3.3.2 Preparing the cable openings
The cables can be fed through openings in the rear wall of the casing or at the bottom
of the casing. The openings are pre-punched and must be prepared as required before
installation.
Prepare the cable openings in the rear wall of the casing as follows:
1. Break out the cable openings

(Fig. 3) using a suitable tool.
2. Deburr the edges.
Prepare the cable openings at the bottom of the casing as follows:
1. Cut the required cable openings

(Fig. 3) at the left and right using a suitable knife
and break them out.
2. Deburr the edges.
3.3.3 Connecting the cables
√ All cables are voltage-free.
√ The cable openings have been prepared.
X
Observe the following points when connecting the cables:
• Connect the cable conductors to the correct terminals as described in the following
Terminal pin assignments section.
• Mains input and output: First connect
PE
, then
N
and
L
.
• Strain relief:
– First clamp the lower strain relief clamps and then the upper strain relief
clamps.
– When using the upper strain relief clamps, use the plastic links as described
below.
– If the opening in the strain relief clamp is too large, e.g. in the case of thin ca-
bles, turn over the strain relief clamping bar (with the bend facing down).
– Only use the strain relief clamps for cables entering the bottom of the casing.
Use external strain relief clamps when feeding cables through the rear of the
casing.
3.3.4 Inserting/Removing plastic links
Insert the plastic links as follows:
1. Insert the right plastic link with the latching protrusion first

(Fig. 4).
2. Press the other side of the plastic strip down

, until the spring clamp latches into
place.
3. Insert the left plastic strip the other way around (latching protrusion to the left,
spring clamp to the right).
Fig. 4: Inserting the right plastic link