Steca TF B001, Инструкция по установке и эксплуатации

Страница: 6 / 24

6
745.089 | 11.30
EN
3.2 Mounting the casing
√ The mounting location must satisfy the prescribed conditions of use; more informa-
tion on this is provided in the Technical data section.
√ The mounting surface is vertical and allows good access for installation.
Danger
Risk of death by electrocution!
• Disconnect the controller from the power supply before opening the casing.
• Make sure that the power supply cannot be unintentionally switched on when the
casing is open.
• Do not use the casing as a drilling template.
1. If necessary, remove the terminal cover
2. Screw in the screw for the upper mounting hole

(Fig. 2) until the screw head has
a clearance of 5 ... 7 mm from the mounting surface.
3. Hang the controller on the screw by the upper mounting hole and align it vertically.
4. Mark the position of the lower mounting hole

through the casing.
5. Remove the controller and prepare the mounting hole for the lower screw.
6. Hang the controller by the upper mounting hole

and then fasten the screw in the
lower mounting hole

.
7. Mount the terminal cover.
Fig. 2: Rear side of the controller with the upper

and lower

mounting holes