Steca TF B001, Инструкция по установке и эксплуатации

Страница: 5 / 24

5
745.089 | 11.30
EN
3 Installation
Note
The following section describes only the installation of the controller . Follow the instruc-
tions of each respective manufacturer when installing external components (pumps,
storage tanks, valves etc.)
3.1 Opening / Closing the casing
3.1.1 Removing the front panel
X
Grasp the front panel

by the grooves at the sides

and pull forwards

(Fig. 1).
Fig. 1: Removing the front panel
3.1.2 Mounting the front panel
X
Carefully position the front panel

and then press it onto the casing until it latches
into place.
3.1.3 Removing the terminal cover
Danger
Risk of death by electrocution!
• Disconnect the controller from the power supply before removing the terminal
cover.
• Make sure that the power supply cannot be unintentionally switched on when the
device is open.
1. Remove the screw (Fig. 1).
2. Remove the terminal cover

.
3.1.4 Mounting the terminal cover
1. Position the cover

.
2. Tighten the screw

to a torque of 0.5 Nm.