Steca TF B001, Инструкция по установке и эксплуатации

Страница: 8 / 24

8
745.089 | 11.30
EN
3.3.1 Position of the connection terminals
Fig. 3: Terminal clamps in the lower part of the controller (terminal cover removed)

Power connection terminal block:
L
1x phase conductor (mains input)
R1
1x output (TRIAC, for pump)
N
2x neutral conductor (common neutral conductors for mains power input
and output)
Note
Output
R1
is protected by an electronic fuse.

Protective conductor terminal block:
PE
4x protective earth (common protective earth for power connection
terminal block)
 Signals terminal block:
PWM R1
1x control output (for controlling a high-efficiency pump)
2x mass connection (common mass)
X
not used

A 1x 4-pin straight connector socket (for polarity-safe Molex plug to Grundfos Direct
Sensors TM VFS or RPS *) )
B 1x pin strip, for internal use only

Cable openings on the rear side of the casing
 Upper strain relief clamps (2 identical plastic links, each with 2 strain relief clamps,
supplied in the scope of delivery)

Lower strain relief clamps

Cable openings at the bottom of the casing
*) Grundfos Direct Sensors TM is a registered trademark of the Grundfos group.