Steca Fronius Solarix 400 I, Руководство по эксплуатации

Страница: 31 / 36

29
TROUBLESHOOTING AND REMEDIES
Condition
Consequence Elimination
appliance overloaded or vent slots
covered Stand-alone inverter lamp is
continuously red
Caution! Prior to opening appliance, disconnect all cables as described under “Connecting the Solarix”, in reverse order.
Check loads for power consump-
tion and ventilation slots - restart
as soon as temperature decreases
load with excessive inrush current
connected check consumers - automatic re-
start following short interruption
low battery voltage Stand-alone inverter lamp
flashes red and green restart as soon as state of charge
of battery exceeds 50 %
ERROR MESSAGES SHOWN AT DISPLAY OF STAND-ALONE INVERTER
ERROR MESSAGES SHOWN AT DISPLAY OF SOLAR CHARGE REGULATOR AND DIGITAL DISPLAY
Cause
no power supplied to consumers
no power supplied to consumers
no power supplied to consumers
to preclude total discharge of
battery
Condition Consequence Elimination
total power consumption too high
or short-circuit of DC output Solar charge regulator lamp
flashes red and green
digital display reads
switch off or disconnect DC loads
- make sure permissible con-
sumer currents are not exceeded
Cause
no power supplied to consumers
solar module current too high Solar charge regulator lamp
flashes red and yellow
digital display reads
automatic restart as soon as over-
current has passed
check maximum module current
of your system no power supplied to consumers
overtemperature Solar charge regulator lamp is
continuously red
digital display reads
check loads for power consump-
tion and ventilation slots - restart
as soon as temperature de-
creases no power supplied to consumers
high battery voltage solar charge regulator lamp
flashes yellow
digital display reads
automatic restart as soon as ov-
ervoltage has decreased no power supplied to consumers,
solar modules in short circuit
low battery voltage solar charge regulator lamp
flashes red
digital display reads
restart as soon as state of charge
of battery exceeds 50 % no power supplied to consumers
to preclude total discharge of
battery
battery capacity less than 200Ah Motor, pump or refrigerator
does not work
stand-alone inverter lamp
shows red light after trying to
start check capacity of battery no power supplied to consumers
cross section of battery cable less
than 10mm², length of battery cable
is more than 125 cm
starting current too high
check length and cross-section
of battery cables
Consumer can not be used
no power supplied to consumers
no power supplied to consumers