STC Smartscan NG2, Руководство пользователя

Страница: 72 / 133

72
14
May 2021, SmartScanNG² User's Guide for Wayside Enclosure Components, EUD-2018086-00 Rev.3
9.4 Fuse Block
There is one fuse block per SmartScanNG² detector. To mount the fuse block and wire it to
the SmartScanNG² detector:
1 Be sure that you have on hand a wire cutter, a wire stripper, a pliers-type crimping tool,
and a midsize slotted screwdriver.
2 Remove all power to the SmartScanNG² detector. Remove the fuse from the fuse block
and store it in a safe place until you replace it (next section).
Using the supplied screws, mount the fuse block and the distribution block near the
SmartScanNG² detector. Be sure that there is enough room above and below the block
to make all connections.
STC supplies each system with 15 feet (4.6 meters) of red-black 10-AWG 2-conductor
zip wire. It may not be necessary to use all 15 feet (4.6 meters) of this zip wire. You
should cut it to the appropriate length for your configuration.
3 Wire fuse block per figure below. Connect to surge suppression panel of the
SmartScanNG² detector (red & black terminal blocks on the right side of DIN rail).
4 If this is a multi-track site, repeat steps 2 through 3 on the other systems.