STC Smartscan NG2, Руководство пользователя

Страница: 105 / 133

EUD-2018086-00 Rev.3, SmartScanNG² User's Guide for Wayside Enclosure Components, 14 May 2021
105
8 Wait about 8 minutes for the heat source to reach operating temperature and stabilize.
The heat source has reached operating temperature and stabilized when the
temperature meter needle remains centered.
Once the temperature stabilizes, calibration may begin. Once stabilized, the
temperature will change less than plus-or-minus one degree Fahrenheit.
9 Take the calibrated heat source to the bearing scanner on the north or east rail.
10 With the power cord to the rear of the scanner, place the calibrated heat source on the
bearing scanner.
Scanner
Type III
Cable
Heat Source
11 To prepare your computer:
a Plug your computer into COM1using a null-modem cable.
CO
M
1
b Turn on your computer.
c Be sure that your computer has installed communications software, that it is set to
use full-duplex, and that the communication settings are 19200 N-8-1.
Use your communications software to open a LOG file and capture the whole
session to the file. When your session is complete, you may then view what you
have done with an editor, print it with a printer, or store it for later retrieval.
d On your computer, open a LOG file.
NOTE: The following menu screenshots depict a typical NG² system. They may not
exactly match your system. Refer to your Operators Guide for a more accurate
representation of your User Interface.