STC Smartscan NG2, Руководство пользователя

Страница: 12 / 133

12
14
May 2021, SmartScanNG² User's Guide for Wayside Enclosure Components, EUD-2018086-00 Rev.3
The power cord at the bottom of the Chassis Assembly powers the heaters in the 2500-512A C
scanner. This cord should be plugged into a grounded three-wire 120-volt outlet. The
minimum operating voltage is 110 volts.
Plugging the cord into an outlet of more than 128-
volts will severely damage your system.
If 2500-512 DC scanners are used, there usually isn't a power cord at the bottom of the
enclosure. If one is present, don't plug it into an outlet because the heaters in these scanners
use 12 VDC.
2.1 Controller Module (2300-602)
The Controller module is the brains of the SmartScanNG² system. It contains the Interface
board, the display panel, and the optional Velocity IP Device Manager. For ease of
maintenance, the module detaches from the SmartScanNG² detector as a separate unit. It is
easily removed by first unplugging the Molex and ribbon cable connectors and then by
removing the fasteners.
Communications with the controller module can be established locally via:

Serial Interface through the local comm port

WIFi Interface (wireless connection)

Display panel/keypad on the front of the controller module
Communications with the controller module can be established remotely via:

Web Interface with an internet connection

Serial Interface through Telnet connection

Serial Interface through a hardline or cellular modem
The figure below shows the major parts of the Controller module (2300-602).
Interface Board
Controller Module Cover
Controller Module Base
Velocity Modem Board
WiFi Antenna
Status Panel