STC Smartscan NG2, Руководство пользователя

Страница: 76 / 133

76
14
May 2021, SmartScanNG² User's Guide for Wayside Enclosure Components, EUD-2018086-00 Rev.3
2 Plug the cable from the bearing scanner on rail1 (that is, from the north or east rail) into
the box connector labeled Rail1.
AUX OUT
WHEEL2 WHEEL1 RAIL2 RAIL1
J3 J2
1 20 1 20
(BOTTOM PANEL)
TRACK
CIRCUIT
1 10
2300-601 NG² Chassis
From Bearing Scanner on Rail1
From Bearing Scanner on Rail2
2300-501 NG Chassis
3 Plug the cable from the bearing scanner on rail2 (that is, from the south or west rail)
into the box connector labeled Rail2.
4 If this is a double-track site, repeat steps 1 through 3 on the second track.
9.7 Wheel Scanners
Not all sites use wheel scanners. If your site doesn't use them, skip to the next section.
If your site uses them, there are two wheel scanners per track. At double-track sites, the
cables from the wheel scanners on track1 connect to the bottom of the leftmost
SmartScanNG² chassis. The cables from track2 connect to the bottom of the rightmost
SmartScanNG² chassis.
To connect the wheel scanners to the SmartScanNG² detector:
1 Be sure that both wheel scanners are installed on the track.