STC Smartscan NG2, Руководство пользователя

Страница: 81 / 133

EUD-2018086-00 Rev.3, SmartScanNG² User's Guide for Wayside Enclosure Components, 14 May 2021
81
9.8.2 Advance Transducers
Not all systems use advance transducers. If yours doesn’t, skip ahead to the next section.
There are two advance transducers per track, each having two wires: one black wire and one
white wire. At a single-track site, the wires should be labeled
ADV1 and ADV2 . At a double-
track site, they should be labeled ADV1-TRACK1 , ADV2-TRACK1 , ADV1-TRACK2 , or
ADV2-TRACK2 , whichever is appropriate. At double-track sites, the wires from the advance
transducers on track1 connect to the leftmost SmartScanNG² detector. The wires from track2
connect to the rightmost SmartScanNG² detector.
9.8.3 Dragging-Equipment Detector
Most, but not all, systems use dragging-equipment detectors. If your site doesn't use them,
skip ahead to the next section.
When used, there is one dragging-equipment detector per track, each having two wires —
usually, one black wire and one white wire. The color of your wires may be different.
At double-track sites, the wires from the dragging-equipment detector on track1 connect to the
leftmost SmartScanNG² detector. The wires from track2 connect to the rightmost
SmartScanNG² detector.
Refer to the wiring chart in Section 9.8 .
9.8.4 High-Load/High-Wide Detector
Some systems use high-load detectors. Others use high-wide detectors. If your site doesn't
use either of them, skip the instructions below and go to the next section.
When used, there is one high-load/high-wide detector per track, each having two wires.
At double-track sites, the wires from the high-load/high-wide detector on track1 connect inside
the leftmost SmartScanNG² detector. The wires from track2 connect inside the rightmost
SmartScanNG² detector.
Refer to the wiring chart in Section 9.8 .
To designate High-Load alarms , YES must appear after the words High Load on the
Equipment menu, and Separate must appear after the words Clearance Mode on the
Equipment menu.
To designate High-Wide alarms , YES must appear after the words High
Load on the Equipment menu, and Multiplexed must appear after the words Clearance Mode
on the Equipment menu.