56
5.
If this still does not work, press the reset button for 10 seconds. This
will place the gateway into its factory default state. Go through the
above procedures again.
6.
Make sure NAT is enabled for your connection. If NAT is disabled the
Lynx L-510 will not route frames correctly (except in Bridge
connection).
The DSL Link LED continues to blink but does not go solid
1.
This means that the DSL line is trying to train but for some reason it
cannot establish a valid connection. The main cause of this is that you
are too far away from the central office. Contact your DSL service
provider for further assistance.
2.
Verify that the phone line is connected directly to the wall and to the line
input on the Lynx L-510.
3.
Make sure that for every parallel phone line connected to telephone or
fax to install with a micro filter.
Common Problems and Solutions
The DSL Link LED is always off
1.
Make sure you have DSL service. You should get some kind of
information from your ISP that states that DSL service is installed. You
can usually tell if the service is installed by listening to the phone line;
you will hear some high-pitched noise. If you do not hear high-pitched
noise, contact your ISP.
2.
Verify that the phone line is connected directly to the wall and to the line
input on the Lynx L-510. If the phone line is connected to the phone
side of the Lynx L-510 or you have a splitter installed on the phone line,
the DSL light will not come on.
