39
denied, most services from the LAN side IP addresses is enabled. Remember
to:
1.
Check Enable Access Control to enable this feature. (This will enable
the IP Access List field)
2.
You can select an IP from the IP Access List, or enter a new IP and
check ADD
3.
Change the LAN and / or WAN configurations of the IP address
4.
Click Apply
Figure 1-32: Access Control
6.3.19
Routing (Static Routing)
If the Lynx L-510 is connected to more than one network, you may need to
set up a static route between them. A static route is a pre-defined pathway
that network information must travel to reach a specific host or network. You
can use static routing to allow different IP domain users to access the
Internet through the Lynx L-510.
The New Destination IP is the address of the remote LAN network or host to
which you want to assign a static route. Enter the IP address of the host for
which you wish to create a static route here. For a standard Class C IP
domain, the network address is the first three fields of the New Destination
