15
Chapter 6
Setting Up the Lynx L-510
The basic tabs consist of features which are catered for basic users.
This section will guide you through your Lynx L-510’s configuration. The Lynx
L-510 is shipped with a standard PPP configuration.
6.1
Logging into your Lynx L-510
To configure your Lynx L-510, open your web browser. You may get an error
message at this point; this is normal.
1.
Type the default IP address (192.168.1.1) or login.router on on the
web address bar.
2.
Press the Enter key and the following screen will appear.
Note: Before sitting up your Lynx L-510, make sure you have followed
the steps detailed in your easy start guide. You should have your
computer configured for DHCP mode and have proxies disabled on your
browser. Upon accessing the Lynx L-510, if the browser still displays a
login redirection screen, you should check your browser’s settings and
ensure that the JavaScript support is enabled. If the screen shown in
Figure 1-5 is not attainable, you must delete your temporary Internet
files to clear the web cache.
Figure 1-3: Setup Page
