-43-
Operation
Slide Switch and Push Buttons
Slide Switch
The slide switch is designed for quick pursuit mode
operation. The far left position (OFF) will not activate
any outputs. Using the default settings, Position
will activate any lights or devices connected to
Terminals 1 and 2 of the 12-terminal connector
(see pages 35-36)
. By default,
position
2
2
2
2
activates any lights or devices connected to Terminals 1, 2, and 3
of the 12-terminal connector
(see pages 35-36)
. By default, position
3
3
3
3
activates all of the lights or devices connected to Terminals 1, 2, 3, and 4 of
the 12-terminal connector, along with the siren
(see pages 35-36)
. Each slide
switch output is protected with a 20A fuse.
Pursuit Mode -
Position
3
3
3
3
(farthest right) is generally used for the full pursuit
mode. It allows for a quick procedure that will activate both the lights and
the siren in one motion. When the slide switch is moved to Position
3
3
3
3
, all
of the lights or devices connected to Terminals 1, 2, 3, and 4 will turn on
and the siren will activate into the Wail mode.
Please review the
Detailed Programming
section
(pages 9-31)
for instruction
on how to change several settings related to the slide switch, including:
Push Button Switches (S1-S7)
Seven push button switches are provided to operate
your external lights or devices. Each push button
(
S1-S7
) will control the corresponding item(s)
connected to Terminals 5-11 of the 12-terminal
connector (see pages 35-36). Each of these seven
outputs is protected with a 20A fuse
(see page 46)
.
By default, buttons
S5
,
S6
, and
S7
are designed for use with a
compatible
arrowstick (traffic director).
S5
is designated for the Warn Pattern.
S6
is
designated for the Left Pattern.
S7
is designated for the Right pattern.
Pressing
S6
and the
S7
button at the same time will activate the Center Out
pattern. When these buttons are used, the corresponding pattern will display
on the LEDs located above the Manual and Air Horn buttons.
In addition, by default, buttons
S5
,
S6
, and
S7
act like radio buttons (when you
activate one, it de-activates the other two). If you will
NOT
be connecting
S5-
S7
to an arrowstick, you can disable the Arrowstick LED display and allow the
buttons to be activated simultaneously. (See page 7 of the
Installation: DIP
Switch Settings
) section.
•
Audio Lockout Unless Slide Switch on
•
Standby Mode Until Slide Switch Activated
•
Change Slide Switch to Non-Progressive Functionality
•
Auto activation of Arrowstick
•
Auto activation of Siren Tones
•
Auto-activation of
S1-S4
