-7-
Installation: Dip Switch Settings
(cont’d)
UP/DOWN DIP Switch Settings
BUZ
Beep Settings
By default, every time a button is pressed on the
keypad, the unit beeps. Flip the DIP switch up to
deactivate this feature.
Please note:
The optional 10-second beep
function will not work if this switch is in the UP
position (see page 15 of the
Detailed
Programming
section for further details)
.
GUN
Gun Lock
This unit is shipped with all of
the Push Buttons (
S1-S7
) set
to be used as standard
On/Off buttons (pressing
each button once turns it ON,
pressing it a second time
turns it OFF). For some
applications it may be desirable to have one or more “Gun Lock”
buttons. A “Gun Lock” button will stay activated for only 10 seconds
when pressed. To activate Gun Lock Mode, flip switch two up. By
default, the fourth push button (
S4
) will become a Gun Lock button.
(See page 14 for detailed instructions on how to change the Gun
Lock button to a different button, to program additional buttons to act
as Gun Lock buttons, or to change the Gun Lock Timer to 20 sec.)
TDM
Traffic Director Mode
This unit is shipped with buttons
S5
,
S6
, and
S7
designated for use
with an approved traffic director (arrowstick). If any one of these
buttons is activated, pressing either of the other buttons will
deactivate the active one. In addition, pressing any of these buttons
will also activate the traffic director display LEDs on the front of
the unit. These LEDs will display
the pattern that corresponds to the
buttons pressed (i.e. Warn, Left,
Right, or Center Out). If you do
not have a traffic director, or your
traffic director uses a separate
controller, and you will be using these buttons as standard On/Off
buttons for other functions, flip DIP switch three up. This deactivates
the display LEDs. In addition, it will also allow you to turn them all
on at once (In TDM mode only one at a time can be active).
