-12-
Detailed Programming Instructions
Once you have programmed each option(s) to the desired setting
(s),
you must
flip the PGM DIP switch down to save the changes.
Installation: Detailed Programming
Button Operation (Open or Closed)
The following section gives a detailed description of how to program each of
the options listed/shown on the previous two pages.
If you do not need to
change any of these options, you may skip to the
Mounting
section on
page 32.
Button Operation (Open or Closed)
All of the Push Buttons (
S1-S7
), by default, operate as a standard switches
(“normally open”). When the unit is powered up the buttons are in the OFF
mode and the switched circuits are “open”. Pressing each button once will turn
them ON and “close” the connection (apply +12VDC). Pressing each button
again will turn them OFF and open the connection again.
If you would like any of these switches to be “closed” (+12VDC applied) when
they are OFF and “open” when they are ON, change this setting.
Place the PGM DIP switch in this position:
Up
Place the Rotary Knob in this position:
Yelp
Place the Slide Switch in this position:
Off
And toggle any of these buttons:
S1-S7
Button is
Green
:
(Default setting for all buttons)
When any of the buttons
are activated (or ON), the circuit is “closed” or “connected”
to +12VDC.
Button is
Red
: The circuit is “open” when ON and “closed” connected to
+12VDC when OFF.
Each button (
S1-S7
) can be programmed independently of the others.
Once you have programmed your option(s) to the desired setting(s),
you must
flip the PGM DIP switch down to save the changes.
