SRS Labs SR430, Руководство пользователя

Страница: 86 / 146

85
Remote Programming
SETUP COMMANDS
OUTP (?) {i} The OUTP command sets the output interface to RS232 (i=0) or GPIB
(i=1). The OUTP i command should be sent before any query commands
to direct the responses to the interface in use.
KCLK (?) {i} The KCLK command sets or reads the key click on (i=1) or off (i=0) state.
ALRM (?) {i} The ALRM command sets or reads the alarm on (i=1) or off (i=0) state.
THRS (?) {i} The THRS command sets or reads the hours setting of the clock. The
value of i is in the range 0 ≤ i ≤23.
TMIN (?) {i} The TMIN command sets or reads the minutes setting of the clock. The
value of i is in the range 0 ≤ i ≤59.
TSEC (?) {i} The TSEC command sets or reads the seconds setting of the clock. The
value of i is in the range 0 ≤ i ≤59.
DMTH (?) {i} The DMTH command sets or reads the months setting of the calendar.
The value of i is in the range 1 ≤ i ≤12.
DDAY (?) {i} The DDAY command sets or reads the days setting of the calendar. The
value of i is in the range 1 ≤ i ≤31.
DYRS (?) {i} The DYRS command sets or reads the years setting of the calendar. The
value of i is in the range 0 ≤ i ≤99.
PLTM (?) {i} The PLTM command sets or reads the plotter mode. If i=0 plotting is di-
rected to the RS232 interface, if i=1 plotting is to the GPIB interface.
PLTB (?) {i} The PLTB command sets or reads the RS232 plotter baud rate. The pa-
rameter i ranges from 0 to 4 and selects baud rates of 300 (0),1200 (1),
2400 (2), 4800 (3), and 9600 (4). This baud rate should match the baud
rate of the plotter in use.
PLTA (?) {i} The PLTA command sets or reads the GPIB plotter address. The param-
eter i ranges from 0 to 30 and should agree with the address of the plot-
ter in use.
PLTS (?) {i} The PLTS command sets or reads the plot speed. If i=0 fast plot speed is
used, if i=1 slow plot speed is used.
PNTR (?) {i} The PNTR command sets or reads the trace pen number. The pen num-
ber is in the range of 1 to 6.
PNGD (?) {i} The PNGD command sets or reads the grid pen number. The pen num-
ber is in the range of 1 to 6.
PNAP (?) {i} The PNAP command sets or reads the alphanumeric pen number. The
pen number is in the range of 1 to 6.