SRS Labs SR430, Руководство пользователя

Страница: 77 / 146

INSTRUMENT SETUPS
DEFAULT SETUP / POWER ON CLEAR
If the [CLR] key is held down when the power is turned on, the instrument settings will be set to the defaults
shown below instead of the settings in effect when the power was turned off.
Menu Item Setting
RS232 Parity None
GPIB Address 8
Overide Remote No
Key Click On
Alarms On
Plot Mode RS232
Plotter Baud Rate 9600
Plotter Address 1
Plot Speed Fast
Trace Pen 1
Grid Pen 1
Alpha Pen 1
Cursor Pen 1
Fit Pen 1
Printer Type 1
File Name None
Type of Fit Line
Operation +
Argument Type Constant
Argument 0.0
Status Enable
Registers Cleared
75
If there is a memory error when the unit is turned on, then the default settings will be used instead of the set-
up retained in memory. This can be due to a low battery.
The default setup may also be recalled using the *RST command. In this case, the communications parame-
ters and status registers are not changed.
Menu Item Setting
Trigger Level 100 mV
Trigger Slope Positive
Discriminator Level -10.0 mV
Discriminator Slope Negative
Aux 1 Level 0.0 V
Aux 2 Level 0.0 V
Bin Clock Source Internal
Bin Width 5 ns
Bins/Record 1k
Records/Scan 1000
Trigger Offset 0
Accumulate Mode Add
Toggle Count 1
Pause At Toggle No
From Offset 0
Cursor On
Cursor Width Wide
Cursor Seeks Maximum
Grid On
Output To GPIB
RS232 Baud Rate 9600
RS232 Word Length 8 bits