SK1265-AT6
Electrical system
Truck
SPIERINGS MOBILE CRANES USER MANUAL V 2.9
6-3
M
ei
2
0
1
8
Cha
n
g
e
s
a
n
d
t
y
p
o
g
ra
p
h
ic
a
l e
rr
o
rs
r
e
s
e
rv
e
d
.
©
2
0
1
8
S
p
ie
ri
n
g
s
M
o
b
ile
Cr
a
n
e
s
–
A
ll r
ig
h
ts
r
e
s
e
rv
e
d
.
6.2.2.
Charging batteries
To charge the batteries, a charger and a cable with NATO connection are needed. When using a quick
charger, all battery cables must be dismounted regarding damage to electronic components.
When using a normal charger, this is not necessary.
Charging the batteries must be carried out as follows:
1. Make sure the engine is not running:
-
Remove the key from the ignition;
2. Open the left-hand engine cowling;
3. Connect the cable with NATO-connection to the connection of the truck and the charger;
4. Turn on the battery charger;
5. Always turn off the battery charger after use;
6. Disconnect the cable with NATO-connection;
7. Close the left-hand engine cowling;
8. Start the engine and let it run for a few minutes.
Recharging batteries by using a quick charger
When using a quick charger, all cables must be removed from the battery clamps and the quick
charger must be attached directly to the battery terminals.
6.2.3.
Replacing batteries
It is recommended to check the batteries first before replacing.
Replacing the batteries must be done as follows:
1. Turn off the ignition of the truck and remove the ignition key;
2. Erect the crane till the tower is in vertical position;
3. Remove the engine cowling;
4. Unscrew the nut and remove the protective cover of the battery;
CAUTION!
Do not charge the batteries of the truck by using the batteries of the superstructure
diesel engine.
Especially in the winter, there is a danger of completely empty batteries.
CAUTION!
Always replace the batteries by new ones of the same type and size.
CAUTION!
Always loosen the battery clamps of the
– terminal first, before loosening the
battery clamps of the + terminal! When dismounting, always follow this order.