SK1265-AT6
Operating the truck
Truck
SPIERINGS MOBILE CRANES USER MANUAL V 2.9
3-31
M
ei
2
0
1
8
Cha
n
g
e
s
a
n
d
t
y
p
o
g
ra
p
h
ic
a
l e
rr
o
rs
r
e
s
e
rv
e
d
.
©
2
0
1
8
S
p
ie
ri
n
g
s
M
o
b
ile
Cr
a
n
e
s
–
A
ll r
ig
h
ts
r
e
s
e
rv
e
d
.
3.9.2.4.
Main screen: Tyre pressure screen
Switch 6
enables the user to navigate to the
Tyre pressure screen
In the top bar A of the screen current warnings are displayed in red and yellow
.
If more than 7 warnings are active, all these warnings can be displayed in another screen
(see
§ 3.9.2.6. Main screen: Error screen
). The symbols are explained in
If the tyre has the prescribed pressure (see
), a transparent (black) tyre will be
visible at the corresponding axle (see
).
If the tyre pressure is high or low, the tyre will be yellow (see
).
There will also be a continuously yellow warning in warning bar A (see
If the tyre pressure is too high or too low, the tyre will be red (see
).
There will also be a red warning in warning bar A (see
).
In the
If there is a “lightning bolt” displayed at the tyre instead of a number (see
),
then there is no measured value of the tyre pressure (no sensor signal available).
If no sensor signal is measured successively after 60 minutes, the yellow icon will appear in the
warning bar A
) and the user must check if all remote controls (belonging to the crane)
are disabled, so they can not cause interference. If then the user must have the tyre pressure system
checked by Spierings Service. The battery of the sensor may be empty.
If all tyres are displayed with
a “lightning bolt” and this icon is flashing in the warning bar,
then there has been a CAN-bus fault.
CAUTION!
Make sure the remote controls (which belong to the crane) are disabled,
so they cannot cause interference in the tyre pressure system.
Picture 3-13
C
A
D
B
E