Spectra Watermakers Farallon 1800, Инструкция по установке и эксплуатации

Страница: 49 / 53

49
OP-2 BAD SMELLING PRODUCT WATER
The reverse osmosis membrane is permeable by many gases including hydrogen sulfide, the gas
that causes rotten eggs to smell the way they do. If there are bad odors in the feed water they
will go through the membrane and the product water will be affected. Usually the source of the
odor is from the decay of planktonic creatures trapped in the sea strainer and prefilters
.
These
tiny oxygen loving creatures soon suffocate and die inside the prefilter housings when the unit
is shut down. Once all the available oxygen is consumed, anaerobic bacteria begin to grow,
causing the odor. If a unit being used frequently begins to make smelly water, it will be the
prefilters that are the source of the problem. This occurs in a week or two in cold climates, but
in less than one night in very warm waters like the Sea of Cortes or Red Sea. These bacteria
can spread throughout the watermaker, and begin to grow on the membrane, causing poor water
quality and high feed pressures. Once bacteria colonize the membrane they are difficult or
impossible to eradicate.
Filling the system with fresh water after every use greatly slows this process, allowing the
automated Spectra units to operate with less frequent prefilter changes, but units operated for
only an hour or so a day will probably need to have the filters changed due to odor before they
are dirty enough to restrict water flow.
When operating in waters where odors are a problem, we recommend that you have three sets in
service, one in the unit, one set soaking overnight in a bucket of clean fresh water and one set
drying for the next use. After shutting down the unit, remove the used prefilters and install the
dry set. Leave the housings full of air until the next use. On non-automated systems, open the
pressure relief when starting if there is a lot of air in the system until the air is cleared out
through the brine overboard. The filters will get just as clean when soaked in sea water, but dry
much faster if soaked in fresh. Given gentle handling, prefilters can be cycled through this
process many times.
Bad smelling product water is usually caused by bad smelling feed water, but can also be
caused by a fouled membrane if the membrane has been left unpickled. If the unit makes
smelly but not salty water after a long idle period and the prefilters are new, the smell can be
eliminated by running the unit unpressurized for an hour or so to flush the membrane.
Odors in the product water can also be eliminated by adding a charcoal filter in the product
water line. Spectra offers a product water filter kit p/n KIT-FLT-CC.
More on this subject is available on our website at www.spectrawatermakers.com.
05/19/06