Spectra Watermakers Farallon 1800, Инструкция по установке и эксплуатации

Страница: 30 / 53

30
Storage Procedure
 Step 1: Push the “Auto Flush” button on the MPC-5000 display, when the first flush has
been completed, press “Stop” to cancel the 5 day interval timer, then press “Auto Flush”
again.

Step 2: Install the 5/8” braided nylon service hose from the service kit on the three-way
valve installed on the brine discharge outlet, and lead the hose to a 5 gallon bucket. Turn
the valve handle to the ‘Service’ position.

Step 3: Push the “Auto Store button: to fill the bucket with 2 gallons of fresh
unchlorinated water. When the bucket has reached the desired level Push the “Stop”
button

Step 4: Connect the hose, using the garden hose barb fitting from your service kit, to the
service port of the Service Intake Module. Lead the hose into the same bucket. Turn the
service valve on the boost pump module 180° to the ‘Service’ position, so the intake is
now coming from the bucket.

Step 5: Mix the storage chemical compound into the water in the bucket.

Step 6: Make sure the pressure relief valve on the Spectra-
Pearson Pump is Open (unpressurized).
 Step 7: Set the switch on the pump module to “Service System” to turn on the feed pump
and boost pump. Circulate the storage chemical in the system for approximately 20
minutes. Set the switch to “Run Auto” when finished.
Clean Up:

Remove the brine discharge service hose from the three-way valve, and turn the valve
back to the ‘Run’ position. You may at this point, if you choose to, pump the bucket dry
by using the feed pump switch. Stop when the bucket is empty.

Turn the service valve 180° back to its original ‘Run’ position, remove the service hose,
and replace the dust cap.

Turn off the AC power to the system.

LEAVE THE PRESSURE RELIEF VALVE OPEN
Pressure Relief
Valve