Specialized 2014 FSR, Руководство пользователя

Страница: 5 / 48

Page 3 of 20
BIKE SETUP SPECIFICATIONS
Seatpost height
1
SEATPOST MINIMUM INSERTION
1
: To prevent damage to the frame, it’s important to have a
minimum amount of seatpost in the seat tube.
Carbon frames:
Small / Medium - 70mm insertion
Large / X-Large - 100mm insertion
Aluminum frames:
If you cannot see the seatpost tube through the seat tube hole, your seatpost is too far extended. If a
greater saddle height is required, replace the seatpost with a longer one.
NOTE: When running a saddle in a low position, it’s important to fully compress the rear end of the bicycle
to ensure that the tire doesn’t contact the saddle. This is especially important on longer travel bicycles.
Frame linkage assembly
E
B C D
C
A
2
Specialized recommends following a specific order when assembling the rear triangle pivot locations
of FSR suspension bike models
2
.
A. Main pivot
B. Main link pivot
C. Horst link or link @ seatstay pivot
D. Lower shock eye or yoke pivot
E. Upper shock eye
Assembling the upper or lower pivots of the seatstay as a last step makes it easier to align the parts
and hold the washers in place.
Down tube cable guide installation
QUAD BAT TRIPLE BAT
3
A A A A B B
D D
E E
C
F F
G G
I
J J
H H
Certain Specialized FSRs are equipped with bolt-on down tube cable guides
3
under the down tube
(3- or 4-cable bats). For proper housing placement and function, the hydraulic rear brake housing
goes in the larger (non-drive-side) inner slot, while the gear cables (4mm only) go on the outside.
Telescoping seatposts with internal routing require the 4-cable bats, with the cable (4mm only) going
in the narrower (drive-side) inner slot.
A. Blue: Gear (narrow outer slots)
B. Red: Brake (larger inner slot)
C. Green: Seatpost (narrower inner slot)
D. Triple or Quad bat rubber base (standard)
E. Triple or Quad bat rubber base (extended)
F. Triple or Quad bat alloy holder
G. Drive-side
H. Non-drive-side
I. Seatpost housing entry port
J. Down tube
NOTE: Stumpjumper Carbon / Enduro models use 2 x
D
and 1 x
E
. Stumpjumper Alloy /Camber
Alloy models use 3 x
D
.
Do not overtighten the guide bolts! Too much pressure can squeeze the cable housings,
creating friction and poor shifting for the cables.
Demo and Status models:
The housings are routed on top of the down tube.
142+ rear axle
„
Certain Specialized bike models are equipped with a 142+ rear axle system, which requires the use of a proprietary Specialized 142+ wheel, or a 142mm
compatible wheel. For additional information regarding compatibility, please refer to the Roval Hub Compatibility Guide at www.specialized.com.
Accessories
„
Specialized offers replacement chainstay protectors for most FSR models, available through your Authorized Specialized Dealer.