Specialized 2014 FSR, Руководство пользователя

Страница: 28 / 48

4
„
Fig.8: If you are not using a Specialized locking grip, insert the supplied shim
B
inside the lever clamp (collar) before sliding it onto the handlebars.
Do not install non-locking grips until the setup is completed.
„
Fig.8: Loosen the 3mm hex and slide the grip/lever (or lever only) onto the handlebars. Slide on the remote, shifter, and brake levers in the order
preferred. The aftermarket lever
C
is hinged and mounts directly to the handlebars.
„ Fig.8: If using Specialized locking grips, torque the 3mm hex to 15 in-lbf (1.7 Nm).
„
Operate the remote lever to ensure it doesn’t interfere with other controls on the handlebar. Relocate the lever if necessary.
2. INSTALLING HOUSINGS - INTERNAL CABLE ROUTING
Command
Post
1
Command
Post
2
„
Fig.1: Insert a derailleur cable head-first into the entry port hole and run the cable down the down tube.
„
Fig.2: Have the cable come out the exit port hole.
3
Command
Post
4
„
Fig.3: Once the cable has exited the frame at the bottom bracket shell, pull extra cable out until only a few inches of cable are visible at the entry
port hole, then tape the few inches of exposed cable to the down tube/head tube.
„
Fig.3: Run the cable head back in through the exit port hole and run the cable up the seat tube.
„
Once the cable exits the top of the seat tube, tape the cable to the outside of the seat tube.
„
Fig.4: Remove the tape from the portion of cable exposed at the entry port hole, then insert a section of shifter cable housing (1700mm length)
over the cable and into the down tube.
„
Work the housing over the bottom bracket shell and up the seat tube until it exits at the top of the seat tube.