Specialized 2014 FSR, Руководство пользователя

Страница: 29 / 48

5
FOAM:
60cm
5 6
„
Fig.5: Insert a 60cm section of foam tubing over the cable housing, through the entry port hole. Once it’s visible through the exit port hole, help
guide the foam tube up over the bottom bracket shell and partially into the seat tube (Section 2, fig.7-A).
„
Fig.6: If only the Command Post IR cable housing will enter the drive-side hood scoop, install the 4mm single-hole hood scoop over the housing.
Specialized recommends crossing the housing(s) to the opposite side(s) for optimum function.
„
If additional housings will be installed in the drive-side hood scoop (e.g., front derailleur), only install the hood scoop after the remaining housings
have been installed into the frame, before completing the installation steps for the Command Post IR. Please refer to the FSR Owner’s Manual for
additional information about installing shifter and brake housings.
„
Fig.6: Once the hood scoop is installed in the entry port hole, flex the housing out of the way and insert a hood scoop bolt into the hood scoop.
Tighten to 6 in-lbf (0.7 Nm).
Cut X
mm
60mm
7
A
C
B
„
Fig.7: Adjust the housing length (be sure to measure twice and cut once!) so that there is enough slack in the housing to compensate for turning the
handlebars to their extreme positions. It is imperative that the cable housing is kink-free along its full length. Once the housing position is determined
at the handlebar
B
, cut the housing so that it’s level with the top of the seat tube
C
.
„ Fig.7: Cut off the length of housing that corresponds to Xmm (the distance from the noted seatpost height to the base of the cable hanger, Section 1, Fig.7).