Specialized 2014 FSR, Руководство пользователя

Страница: 42 / 48

5
B r a k e s
Install your brakes according to the manufacturer's instructions and adjust the brake pads
properly. Use only disc style brakes on the provided disc mounting holes.
N OT I C E
Do not let brake or derailleur cables rest on, or be attached to the crown. Abrasion
over time may cause damage to the crown. If contact is unavoidable, use tape or similar
protection to cover the surface. Crown abrasion is not covered under warranty.
W h e e l I n s t a l l a t i o n
Check tire clearance whenever you change tires. To do this, remove the air pressure or coil
spring from the fork, then compress the fork completely and ensure there is at least 6 mm of
clearance between the top of the inflated tire and the bottom of the crown.
For complete instructions, refer to the RockShox Service Manual at www.sram.com.
WA R N I N G
Failure to leave 6 mm clearance between the top of the inflated tire and the bottom of the
crown will cause the tire to jam against the crown when the fork is fully compressed which
can result in severe and/or fatal injuries.
Riding with an improperly installed wheel can allow the wheel to move or disengage from
the bicycle, causing damage to the bicycle, and serious injury or death to the rider. It is
essential that you:
• Ensure that your axle, dropouts, and quick release mechanisms are clean and free of dirt
or debris. Always check and clean this area when reinstalling the wheel. Accumulated
dirt and debris can compromise the security of the axle, leading to serious and/or fatal
injury.
• Ask your dealer to help you understand how to properly secure your front wheel using
the Maxle quick release thru axle system.
• Apply the correct techniques when installing your front wheel.
• Never ride your bicycle unless you are sure the front wheel is installed properly and
secure.