SR100 REMOTE CONTROL CAR ALARM SYSTEM
11
GREEN WIRE-ALARM ANTENNA
The GREEN antenna wire must not be cut or connected to anything
metal otherwise the alarm operating range will be affected. Extend
the GREEN wire and secure to the outside of the wiring harness to
achieve optimum performance. Ensure the wire cannot come into
contact with a hot surface, bare metal or immersed in water.
YELLOW WIRE-ELECTRIC FAN INHIBIT
IMPORTANT:
If you have a mechanical cooling fan or the electric
fan does not operate with the ignition turned off,
then the yellow wire MUST be connected to a good
earthing point BEFORE connecting the RED wire
of the alarm.
If the electric fan still operates when the ignition is turned OFF then
a connection from the SR100 must be made to prevent the current
sensing function from triggering the alarm. The cooling fan wiring
will be configured as shown in Fig. 4 or 5.
NOTE: The engine must be cold before proceeding.
Locate the fan thermal switch by tracing the wiring from the fan
motor. Connect the YELLOW wire as shown in Fig. 4 or 5 using a
solder joint or a crimp termination to the wire which runs between
the fan motor and thermal switch.
Fig 4
Fig 5
