SR100 REMOTE CONTROL CAR ALARM SYSTEM
10
ARMED INDICATOR LED
Remove the retaining nut from the LED bezel.
Drill a suitable
mounting hole in the dashboard where the indicator LED may be
seen from the exterior of the vehicle as a visible deterrent.
Feed the two way connector and wire through the hole and secure
the LED with the retaining nut (see Fig. 3).
Route the wire through a bulkhead grommet to the alarm and push it
carefully through the flexible boot.
Insert the two way connector into the socket on the rear of the alarm
unit.
PURPLE AND GREY WIRES-INDICATORS
PURPLE (R/H): Using the vehicles wiring diagram or with the aid of
a 12 volt test lamp, locate the wire at the indicator switch which
illuminates the test lamp when the RIGHT indicator flashes.
Connect the PURPLE wire to this wire using a solder joint, crimp
termination’s or an IDC connector.
GREY (L/H): Repeat the above procedure connecting the GREY
wire to the LEFT hand indicator circuit.
NOTE:
The Alarm gives a 12 volt (+) positive output to flash the
indicators. In the rare case where indicators are negatively
(earth) switched, contact Sparkrite for assistance.
