SR100 REMOTE CONTROL CAR ALARM SYSTEM
5
REMOTE PANIC
If you feel threatened outside of your vehicle and within range you can trigger your
SR100 by holding the remote control button depressed for 3 seconds.
This will
commence an alarm cycle of 30 seconds and draw attention to your situation and
the vehicle. The alarm can be silenced by pressing the remote control button again.
PASSIVE ARMING/CURRENT SENSING DISABLE
PASSIVE ARMING
Passive arming is a feature whereby the alarm will automatically “arm” a short time
after the last door on the vehicle has been closed.
Disarming the alarm is achieved by pressing the remote control button or by turning
on the vehicle ignition.
To switch ON the passive arming feature, move switch
number TWO located on the rear of the alarm to the ON position, as shown on page
9.
MPORTANT NOTE:
If passive arming is selected, when the last door of the
vehicle has been closed, the LED will flash for 15
seconds followed by one chirp from the siren. The LED
will then light continuously for 15 seconds, then revert to
flashing mode to indicate the alarm is fully armed.
CURRENT SENSING DISABLE
If the vehicle has any electrical accessory which draws power from the battery when
the vehicle is parked i.e. car telephone, electro-mechanical mechanical clock, (pre
1980). It will be necessary to disable the current sensing feature to reduce the risk
of false alarms.
This is done by ensuring switch number ONE is in the downwards (OFF) position-
see page 9