SR100 REMOTE CONTROL CAR ALARM SYSTEM
7
FITTING INSTRUCTIONS
IMPORTANT:
•
Your SR100 is suitable for 12V negative earth vehicles only.
•
Refer to Car Owners manual for the procedure for disconnection of your
battery before commencing the installation of this Alarm.
•
The vehicle battery must be disconnected during the installation procedure
except where it is necessary to carry out circuit testing specified.
•
Vehicles fitted with digital radios having a security code or memory feature will
require re-programming on completion of the installation.
•
Ensure you have noted the security code of your radio to disconnecting the
vehicle battery.
•
It is suggested that the alarm is tested before the ultrasonic unit has been
fitted.
VEHICLE WIRING TESTING
If you are unable to easily identify the correct wire on the vehicle to make a
connection it is recommended a 12 volt test lamp or multi-meter is used. Care must
be taken to ensure that the wire being tested is not accidentally shorted to earth by
the test lamp or multi-meter probes.
INSTALLATION NOTES
The wiring harness is fully assembled and supplied with in-line fuses on the RED
wire (10 amp), VIOLET (5 amp) and GREY (5 amp) wires, if any fuse blows, it is
essential to investigate the cause and then replace with a fuse of the correct rating.
When routing the harness around the engine compartment and through a bulkhead
inside the vehicle ensure the wires insulation cannot be damaged in sharp metal
edges. The harness should be concealed and protected wherever possible by using
good quality insulation tape.
It is recommended that wherever possible connection to the vehicle wiring is carried
out at the steering column or at the fuse box. This will prevent tampering of the
wiring from outside of the vehicle.
