SR100 REMOTE CONTROL CAR ALARM SYSTEM
13
PINK-IGNITION INPUT
Using a test lamp, locate a 12 volt wire on the ignition switch, which
is live ONLY in the STARTING and RUN positions of the ignition
key. This is normally the wire that becomes live when the ignition
key is turned from position 1 to position 2.
Connect the PINK wire using the procedure described on page 10.
NOTE:
The auxiliary power supply to radios/cassettes must
not be used.
BROWN/ORANGE WIRE-VEHICLE IMMOBILISATION
Vehicle immobilisation is performed by inhibiting the starter motor
operation. This is done by breaking the power to the starter solenoid
drive. Identify the thin wire on the starter solenoid which prevents
the starter motor operating when the wire is disconnected from the
solenoid terminal. Connect the BROWN alarm wire direct to Starter
solenoid terminal. Connect the ORANGE alarm wire direct to the
wire previously removed from the starter solenoid using the in-line
crimp connector supplied.
IMPORTANT:
The immobiliser wires should be kept as short
as possible and any excess wire cut off.
Ensure all wiring is correctly secured and that the insulation on the
wire cannot be damaged on sharp metal edges.
Connect the
immobiliser harness to the matching connector from the alarm unit.
RED WIRE-POWER SUPPLY CURRENT SENSING
NOTE:
The Current Sensing feature will only operate if Selection
Switch No. 1 is in the ON position. (This is located on the
rear of the Alarm).
It is also important that the BLUE Door Wire is connected and
that the Valet Key Switch is in the Enable position before
attempting to connect the RED wire.
The SR100 is triggered by the operation of the interior light or any
electrical circuit on the vehicle. This is detected by the RED power
supply wire. The trigger sensitivity will vary from vehicle to vehicle
depending on size and age of the car battery and the rating of the
interior light bulb. As a general principle the sensitivity will increase
the further from the battery the main supply connection is made. For
reliable operation the interior light should be rated at 10watts
minimum.
To determine the best connection point a simple test
procedure should be followed as below.