Spacelabs Healthcare elance 5, Руководство по обслуживанию

Страница: 30 / 94

Maintenance
•
Select Respiration Lead in Channel 2
•
Disconnect LL (Red)
– Observe that the RESP waveform disappears
•
Reconnect LL, Disconnect RA (White)
– Observe that the RESP disappear
– Reconnect RA
•
Record results
Temperature
• Connect a temp probe to the monitor.
• Leave the temp probe in room temp for 3 min.
• Observe that the monitor displays the room temp.
• Hold the temperature probe and wait for 3 min.
• Observe that the monitor displays approx. 36.5 degrees Celsius or your body surface temperature.
IBP
•
Set P1 IBP Systolic alarm limit to 110(L) and 130(H), Diastolic alarm limit to 70(L) and 90(H),
Mean alarm limit to 85(L) 105(H).
•
Set the simulator to generate Systolic pressure below 110mmHg. Observe that the monitor
generates P1 IBP Systolic low limit alarm.
•
Set the simulator to generate Systolic pressure above 130mmHg. Observe that the monitor
generates P1 IBP Systolic high limit alarm.
•
Set the simulator to generate Diastolic pressure below 70mmHg. Observe that the monitor
generates P1 IBP Diastolic low limit alarm.
•
Set the simulator to generate Diastolic pressure above 90mmHg. Observe that the monitor
generates P1 IBP Diastolic high limit alarm.
•
Set the simulator to generate Mean pressure below 85mmHg. Observe that the monitor generates
P1 IBP Mean low limit alarm.
•
Set the simulator to generate Mean pressure above 105mmHg. Observe that the monitor
generates P1 IBP Mean high limit alarm.
•
Same setting and test apply to P2.
EtCO2
•
Connect the EtCO2 sampling line to a 5% CO2 gas cylinder output port. Verify that the EtCO2
reading on the monitor is 38mmHg
±
2mmHg.
• Set the EtCO2 alarm high limit to 30mmHg. Verify that the monitor generates EtCO2 high limit
alarm.
•
Set the EtCO2 alarm low limit to 45mmHg. Verify that the monitor generates EtCO2 low limit
alarm.
Network
• Check: Central Waveforms match monitor
• Check: Central Parameters match monitor
• Record results
4-7