Sovan's CTD10R-E, Руководство по эксплуатации

Страница: 43 / 45

38
out, and make sure that the wind hole is in effect. Open the cover of the battery (or separate room)
to exhaust the gas and thermal.
In the battery charging area, should adopt measures to prevent open flame, spark or electric arc.
Smoking is forbidden.
The tools and other metal substance should put far away from the top of the battery without cover.
The top of the battery should keep dry; the connection terminal should keep clean, wipe a little
vaseline and screw down correctly.
Without approval, the battery of different voltage, weight or size could not replace the former one in
the vehicle.
When reinstalling the battery, the battery should be put on the correct place.
Inspecting the liquid surface in the battery using open fire is forbidden.
When getting the solvent in the acid carboy, the acid carboy tilting device or siphon pipe could be
used. When diluting oil of vitriol confect the electrolyte, only adding the oil of vitriol into water is
permitted, not add water into oil of vitriol.
15 Maintenance
15.1 General description
Good performance of the motor industrial truck depends upon maintenance. Truck may damage
personal health and properties in case of maintenance neglect.
15.2 Maintenance items
The following items shall be carried on for all motor industrial vehicles shall be in accordance with
schedule, especially with maintenance instructions supplied by the manufacture.
Only professional and qualified maintenance personnel are allowed to go along with the inspection,
maintenance, modification and repair.
15.2.1 Brake set, steering mechanism, control mechanism, alarming device, lighting, adjustor, and overload
protection device for lifting shall be kept within safe operation condition.
15.2.2 Regular inspection shall be taken for components and members of lifting and inclination systems,
which shall be kept within safe operation condition.
15.2.3 Regular inspection shall be taken for safety protection shelf and safety devices, which shall be kept
within safe operation condition.
15.2.4 Regular inspection and maintenance shall be taken for all the hydraulic systems.
Inspection must be taken for oil cylinder, valve, and other similar components to ensure that internal
leakage or external leakage would not develop into a dangerous condition.
15.2.5 Inspection and maintenance shall be taken for storage battery, driving motor, contactor and controller,
limit switch, protection device, lead wire and connecting assembly, which shall be kept within safe
operation condition. Special attention shall be paid to electrical insulation state.
15.2.6 Inspection for damage and leakage must be taken for exhaust gas system of internal combustion
truck, adjustor of carburetor, evaporator, and fuel injection pump.
Notice: hazardous substances may be produced by the internal combustion engine in
case of operation under close place. Sufficient ventilation is recommended in that
condition.
15.2.7 Check damaged condition of wheel tread, side face and wheel rim of the air-filled type pneumatic tire.
Pressure of the tire that is specified by the manufacture must be kept. Gas in the tire shall be firstly be
released before dismantling the air-filled type pneumatic tire from separable rim.
15.2.8 Check the bonded condition between solid tire and metal wheel band or wheel rim. Foreign matters
on wheel tread of the tire shall be cleared if necessary.