35
In crossroads and the occasion that would obstruct the driver’s sight, the driver must reduc
e the
speed of the truck, and issue sound signal.
When the truck is operating with load, the driver must control turning equipment and brake system
slowly and stably.
In crossroads and the occasion that would obstruct the driver’s sight or some dangerous o
ccasion,
the truck must not exceed other truck moving at the same direction.
The driver must avoid the truck rolling over some fluffy object in order to avoid article damages or
personnel hurts.
It is forbidden that to put the arms , legs or the head in th
e columns of mast or between the truck’s
other moving components.
When the vehicle is running, the driver must not let his body outside the contour line of the truck.
When turning, if there are some other trucks or pedestrians, the driver must issue warning signal.
The driver must comply with all labels about ground load carrying capacity and requirements of other
instructive labels.
The driver must pay special attention to the load carrying capability of slopes and channels leading to
electric elevator.
14.2.3.2 Vehicle speed
The truck speed should coordinate with the status of person’s activity, visibility, road or the ground
conditions and load conditions of the running area. When the vehicle is moving on wet and smooth
road surface the driver must be very carefully.
Under any situation, the vehicle speed must be controlled within the range that the truck can be
stopped safely.
14.2.3.3 Running on the slope
When operating on the slope, the following regulations must be obeyed:
A)
Moving up and down a slope slowly.
B)
Except for the side loading and no lifted load truck, it may as well make the bearing load
device’s surface towards the downgrade direction.
C)
Turning on the slope and bestride the slope are all forbidden.
D)
When the vehicle is near the slope, high platform or platform edge, the driver must drive
carefully. The distance between the vehicle and the platform or platform edge must keep at
least a truck tyre width.
E)
When the gradient is more than 10% during the truck’s running up and down the slope, if
possible, when the lifted load truck and flat stacking truck (except the side bearing load fork-lift
truck, cross-country fork-lift truck , stride- truck and platform carrying vehicle) moves, the load
surface must be in a upgrade direction.
F) When the truck works on various slopes, the load and the load bearing device must tiltt backward
(if possible), and the driver can only elevate the load’s height that is enough for running through
the road surface and local barrier.
14.2.3.4 Get across a gap
It must be ensured that under hanging devices (such as: lamps, pipeline and fire extinguishing
system) there is an enough clearance height.
Before getting across the passage and door, it must be ensured that there is an enough gap among
the vehicle, the driver and the load.
14.2.3.5 Working in road truck and railroad vehicle
Before a motor-driven industry truck runs on (or run down) the road vehicle or railroad vehicle, some
Содержание CTD10R-E
Страница 1: ...CTD10R E Electric Pallet Stacker Operation Manual Parts Catalogue ...
Страница 6: ...1 1 Outline drawing 1 1 CTD10R E Outline drawing ...
Страница 31: ...26 Hydraulic Schematic Diagram standard ...
Страница 32: ...27 AC 220V E 24V 65Ah CH 24V 10A CURTIS 1212 Electric Schematic Diagram standard ...