12
put the goods carefully on the shelf. Take the fork away from the goods and drive the stacker slowly to make the
fork out of the goods pallet. (The tip of the fork is 300mm from the goods shelf.) Lower the fork until it is
300mm from the ground and drive the stacker away from the shelf. Attention should be paid to that there
should be no obstacles around and when turning, the speed should be reduced.
Caution
The driving mechanism of truck is installed on the foreside. Due to this
difference from common vehicles, the foreside of truck swings comparatively fast
when turning around. For this reason, to prevent collision with other objects nearby
the foreside of truck, do drive or turn slowly.
5
.
2
.
5 Operation of taking goods off the goods shelves
:
As indicated in Fig. II, pull out the general power supply switch, unlock the electric door lock, and drive the
stacker to the goods shelf nearby. (The tip of the fork is 300mm from the goods shelf). Press the lowering button,
adjust the height of the fork to a proper position, and insert the fork slowly and as deep as possible into the pallet
of the goods. Press the lifting button to lift the goods till the bottom of the pallet is 100mm from the goods shelf.
Slowly drive the stacker and slowly move the goods out of the shelf (the tip of the fork is 300mm from the goods
shelf). Press the lowering button and the fork lowers to a height of 200-300mm from the ground. Drive the
stacker away from the goods shelf until it reaches a desired position and then slowly stop it. Press the lowering
button to put down the goods, make the fork completely away from the goods and move the fork slowly out of
the goods pallet.
5
.
3 Abnormal situation handling during operation
:
5
.
3
.
1When pressing the lifting button, the fork can rise but when releasing the lifting button, the fork is still
rising. The stacker is in a situation of out of lifting control. In that case, turn off the general power supply switch
to cut off the power supply at once. Drive the stacker to a safe position to lower the fork manually and repair the
circuit of the stacker.
5
.
3
.
2 If the brake is out of function when the stacker is in operation, the operation must be stopped at once and
repair the stacker.
5
.
3
.
3 When the stacker is moving forward and pushing the operator against a wall or other objects, press
the emergency reverse button on top of the operation handle and the stacker will automatically move backward
to avoid injuring the operator.
5
.
4 After operation
:
After operation, the stacker should be parked in a fixed parking position and routine maintenance should be
conducted according to the stipulations in clause 6 and charging should be carried out.
6
.
Use, maintenance and charge of the storage batteries
Charging operation methods: This stacker is equipped with a fixed charger. And other built-in chargers are
also optional. When the fixed charger is used for charging, first open the side door to pull out the socket
connector to insert it into the socket joint of the fixed charger. Then insert the plug of fixed charger into two
phase AC power. Finally the charger will start charging after several seconds. When the built-in charger is used
for charging, first open the cover of battery case to take the charging plug out of the battery case, then insert
the charging plug into the two phase AC power. And the charging will start after several seconds.
Содержание CTD10R-E
Страница 1: ...CTD10R E Electric Pallet Stacker Operation Manual Parts Catalogue ...
Страница 6: ...1 1 Outline drawing 1 1 CTD10R E Outline drawing ...
Страница 31: ...26 Hydraulic Schematic Diagram standard ...
Страница 32: ...27 AC 220V E 24V 65Ah CH 24V 10A CURTIS 1212 Electric Schematic Diagram standard ...