20
Support the side near to driver of truck with square timber to lift the driving wheels of truck from the
ground.
Apply a layer of flimsy oil or grease on all the bared surface of mechanical parts.
Lubricate the truck.
Check the status of storage battery and electrolyte, and imbrue the non-acid lubricating grease to the
binding post of storage battery.
All the electrical contacts should be sprayed using appropriate contacts spray.
10
.
2 Transportation of truck:
If the truck needs to be transported for a long distance, support the side near to driver of truck with square
timber to lift the driving wheels of truck from the ground. The two front wheels of truck shall be fixed stably
by sphenoid wood block. Fasten the truck to transport vehicle with ropes.
10
.
3 Loading and unloading of truck:
Before loading the truck, check out the nameplate for the total weight of truck to choose appropriate
hoisting handling equipment. The hoisting of truck shall be kept level, and landing shall be kept slow
and stable. The personnel around shall watch for safety. One of the personnel is responsible for
conducting. If the other truck is used for loading and unloading, please watch the bottom situation of
the truck. Take care to insert the fork arms to the bottom, in avoidance of damaging the driving wheel,
balance wheel and forward wheel.
11
.
Replacement of storage battery
The replacement procedure of storage battery is as follows:
1.
Open the side door of storage battery and take it down.
2.
Pull down the socket connector of storage battery from the truck.
3.
Pull out the pin of battery case to loosen the battery.
4.
Pull out the storage battery from the side way and take the storage battery away with special
car or using hoisting method.
5.
The mounting method of putting the storage battery back into the battery pack is opposite to
the above procedures.
Notice
Handle the storage battery gently during hoisting and transportation of the battery. Otherwise it
will cause damage to the battery or bring danger to human body.
12
.
Common faults and trouble shooting:
No.
Faults
Possible causes
Trouble shooting
1
The
stacker
can
notstart.(The contactor
does not work either)
①
The fuse of control circuit is burnt
out.
Replace
②
The power switch is in poor
connection or is damaged.
Repair or replace
③
Fuse of main circuit is blown.
Replace
④
The switch of electric lock is in poor
connection or damaged.
Repair or replace
⑤
The connection of the storage
batteries is loose or has fallen off.
Tighten
Содержание CTD10R-E
Страница 1: ...CTD10R E Electric Pallet Stacker Operation Manual Parts Catalogue ...
Страница 6: ...1 1 Outline drawing 1 1 CTD10R E Outline drawing ...
Страница 31: ...26 Hydraulic Schematic Diagram standard ...
Страница 32: ...27 AC 220V E 24V 65Ah CH 24V 10A CURTIS 1212 Electric Schematic Diagram standard ...