southpaw enterprises In-FUN-ity Climbing System, Инструкция

Страница: 7 / 23

Safety Precautions - The safety of your clients is dependent on the appropriate choice of activity to match, yet challenge their
physical abilities. Use appropriate spotting / safety techniques. In addition, the layout of your activity area, proper installation and
maintenance of your equipment is critical. Southpaw equipment is not intended for recreational or outdoor use. Under no condition
should this equipment be used without proper supervision.
This sheet is for example only. It is not meant to, in any way, replace local, county, state, or Federal standards. Be aware - it is
your responsibility to find all pertinent safety information that pertains to your facility.
Southpaw
Enterprises Inc.
®
If you have any questions or comments, please call or write
Southpaw Enterprises, Inc.
P.O. Box 1047, Dayton, Ohio 45401 -1047
Toll Free - (800) 228-1698
Come see us on the World Wide Web at http://southpawenterprises.com
Drill a 11/16” diameter hole through the wall and the studs at each
of the marks.
(Hint: You may wish to drill a smaller pilot hole and
enlarge the hole with the 11/16” diameter bit). Remove the toggles
from the bolts. Put one split lock washer and two fender washers
on each bolt. Put a bolt through each of the slots from the front (the
side with the ladder rungs). Screw the toggles back onto the bolts
making sure that the “wings” of the toggle fold back toward the
head of the bolt. Screw the bolt into the toggle until the end of the
bolt is just through the toggle. (See Fig. 2 on reverse side). Reposi-
tion the ladder on the wall and align the slots with the holes.
Fold back the “wings” on each bolt and push them through the
holes in the wall. Tighten each bolt securely.
MAINTENANCE CHECKLIST:
All of the following wear points should be checked on a monthly
basis and recorded on the checklist enclosed.
•
Check that all screws and bolts are tight. If any screws or bolts
are found to be loose, discontinue use until they are tightened.
•
Check wood surfaces for cracks and splinters. If cracks are
found, discontinue use immediately and contact Southpaw
Enterprises. Splinters may be sanded smooth and refinished
with clear lacquer.
MATTING PRECAUTIONS:
•
Always use appropriate matting under and around equipment.
STORAGE PROCEDURE:
•
Make sure that equipment is not accessible by clients without
proper supervision.
CLEANING INSTRUCTIONS:
•
Check with your infectious disease department before using
these procedures.
•
Check for client allergies first.
•
Clean with a damp cloth using soap and water or disinfectant.
•
Dry before using.
Fig. 2
FORM CODE: XI-152001 © 2004 Southpaw Enterprises, Inc.