southpaw enterprises In-FUN-ity Climbing System, Инструкция

Страница: 10 / 23

southpaw enterprises, inc.
®
Instruction Sheet
In-FUN-ity Scooter Board Ramp 152011
Store these instructions along with the enclosed maintenance checklist
in a safe place. You may also access them on our website.
Take time to familiarize yourself with the use and maintenance of this equipment before using. Please file
this Instruction Sheet in an accessible location: the Instruction Sheet must be read and familiar to anyone
who is using Southpaw Enterprises Equipment.
IMPORTANT: Please check equipment immediately for any damage that may have resulted during shipping.
If any damage has occurred, please contact Southpaw Enterprises, Inc. immediately.
MATERIALS LIST:
1 - Ramp (Two pieces).
2 - Clamp Knobs
2 - Large 3/8” Washers
1 - Instruction Sheet
1 - Maintenance Checklist
WORKING LOAD: 200 lbs
The In-FUN-ity Climbing System is a modular system. Each instruction sheet is designed to assist you in assembling the
particular item that it accompanies. Since these items may be configured in various manners to best suit your application,
the instructions do not suggest any particular order of assembly. If you have any questions about how to set up your sys-
tem, please contact Southpaw customer service for help.
ASSEMBLY:
Unpack all pieces of the ramp and place them on the floor. Position the
two pieces as shown in fig.1, with the longer ramp piece laying top-side
down.
Align the holes for the knobs in the ’bent’ end of the top ramp piece with
the holes in the ramp that have the threaded inserts. Place a 3/8” washer
on each knob, then put the threaded end of the knob through the hole
(fig.1) and screw it into the threaded insert (fig.2). Repeat this procedure
on the opposite side of the ramp. Push the attachment piece down until
the wood dowel is seated in the notch in the ramp and tighten the knobs.
Turn the ramp over and attach the assembled ramp to the ladder wall
by hooking the notch in the end of the top piece to the second rung from
the bottom of the ladder.
The inclined ramp may be used alone without attaching the top board.
You may place it on the ladder at what you determine to be the appropri-
ate height.
MAINTENANCE CHECKLIST:
All of the following wear points should be checked on a monthly basis and
recorded on the checklist enclosed.
•
Check that all screws and bolts are tight. If any screws or bolts are
found to be loose, discontinue use until they are tightened.
•
Check wood surfaces for cracks and splinters. If cracks are found,
discontinue use immediately and contact Southpaw Enterprises. Splinters may be sanded smooth and refinished
with clear lacquer.
MATTING PRECAUTIONS:
•
Always use appropriate matting under and around equipment.
Figure 2
THREADED
INSERTS
Figure 1 HOLE FOR KNOB
TM