southpaw enterprises In-FUN-ity Climbing System, Инструкция

Страница: 15 / 23

Safety Precautions - The safety of your clients is dependent on the appropriate choice of activity to match, yet challenge their
physical abilities. Use appropriate spotting / safety techniques. In addition, the layout of your activity area, proper installation and
maintenance of your equipment is critical. Southpaw equipment is not intended for recreational or outdoor use. Under no condition
should this equipment be used without proper supervision.
This sheet is for example only. It is not meant to, in any way, replace local, county, state, or Federal standards. Be aware - it is
your responsibility to find all pertinent safety information that pertains to your facility.
Southpaw
Enterprises Inc.
®
If you have any questions or comments, please call or write
Southpaw Enterprises, Inc.
P.O. Box 1047, Dayton, Ohio 45401 -1047
Toll Free - (800) 228-1698
Come see us on the World Wide Web at http://southpawenterprises.com
•
Two angle brackets are provided to attach the bottom of the vertical ladder to the floor.
Position the bracket on the floor on the outside of the ladder leg with the small holes on
the floor. Put one of the 3/8” x 1-1/4” cap screws through the large hole in the bracket
and through the hole in the bottom of the ladder. Put a 3/8” flat washer on the bolt then
start a 3/8” acorn nut onto the bolt. Making sure that the bottom of the bracket in parallel
with the floor, Tighten the nut using a 9/16” wrench while holding the cap screw with the
hex key wrench provided. Install the bracket on both sides of the ladder. Screws are
provided to secure the bracket to either wood or concrete floors. For concrete floors, drill
pilot holes using a 3/16” masonry drill bit using the holes in the bracket as a guide. Drill
the pilot holes 1-1/2” deep. Vacuum the dust out of the holes and start the 1/4” x 1-1/4”
concrete screws (blue) into each hole. Tighten securely using either a flat blade screw-
driver or a 5/16” wrench. For wood floors, drill pilot holes 1” deep using a 3/32” drill bit.
Use the wood screws provided to secure the brackets to the floor. Note: vinyl tile floors
may have either wood or concrete underneath. Determine which before drilling.
MAINTENANCE CHECKLIST:
All of the following wear points should be checked on a monthly basis and recorded on the checklist enclosed.
•
Check that all screws and bolts are tight. If any screws or bolts are found to be loose, discontinue use until they are
tightened.
•
Check wood surfaces for cracks and splinters. If cracks are found, discontinue use immediately and contact South-
paw Enterprises. Splinters may be sanded smooth and refinished with clear lacquer.
MATTING PRECAUTIONS:
•
Always use appropriate matting under and around equipment.
STORAGE PROCEDURE:
•
Make sure that equipment is not accessible by clients without proper supervision.
CLEANING INSTRUCTIONS:
•
Check with your infectious disease department before using these procedures.
•
Check for client allergies first.
•
Clean with a damp cloth using soap and water or disinfectant.
•
Dry before using.
FORM CODE: XI-152013 © 2004 Southpaw Enterprises, Inc.
Figure 4