Parameters
Cautions:
1 Can not use the electric generator to test the LED lamp.
2 Please abide by related country, regional and local law and regulations when install this fixture.
3 To avoid electrical shock and damage, please do not install the lights in raining days.
Notices:
1 To prevent from electric shock or fire risk, the installation must be conducted by operator who have
professional electrical knowledge.
2 Please wear gloves to avoid injury before installing lamps.
3 During or after installation, if there are situations such as smoke, fire in the wires or lamps, please
turn off the power immediately and notify relevant personnel of an overhaul.
Installation - surface mounting:
1. Please find a professional to install the LED sports light.
2. lamp installation and wiring must be operated in case of power failure.
3. Do not disassemble any part of the fixing device.
4. Please do not use corrosive solution to clean the LED sports light. Please use a dry rag.
5. Please refer to the lamp label for product specifications.
Rated Current
Part No.
FGE-HR-300WYYK
300W
3.3A
4.4A
5.5A
6.6A
8.8A
11A
13.2A
400W
500W
600W
300W
400W
500W
600W
800W
1000W
1200W
800W
1000W
1200W
FGE-HR-400WYYK
FGE-HR-500WYYK
FGE-HR-600WYYK
FGE-HR-800WYYK
FGE-HR-1000WYYK
FGE-HR-1200WYYK
AC100-277V
50/60Hz
AC277-480V
50/60Hz
Input Voltage
Frequency
Power
Installation Instruction
：
INSTALLATION INSTRUCTION
1. Align the holes of the bracket with the mounting
holes already reserved on the wall, put on the flat
washers and spring washers
，
Bolt. Tighten the bolt
to lock into the wall (upside or front-side)
2. Loosen the bolts and screws on both sides with
a wrench and allen wrench, turn the fixture to the
proper angle, then tighten the bolts and screws
back to finish installation.
Lock into upside Wall
bolt
spring washer
allen wrench
wrench
bolt
screws
flat washer
Lock into upside Wall
FGE-HR-300WYYK
FGE-HR-400WYYK
FGE-HR-500WYYK
FGE-HR-600WYYK
FGE-HR-800WYYK
FGE-HR-1000WYYK
FGE-HR-1200WYYK
YYK represents the CCT: 4000K, 5000K, 5700K.
1.19A
1.59A
1.99A
2.38A
3.18A
3.97A
4.77A
3. Wiring Diagram: Input wire (three cores): black,
white, green Dimming wires: (two cores): purple, gray
bolt
spring washer
allen wrench
wrench
bolt
screws
flat washer
Lock into upside Wall
Lock into front-side Wall
Lock into front-side Wall
Lock into front-side Wall
purple DIM+
black L white N green
gray DIM-
purple DIM+
black L white N green
gray DIM-
1.Make the bracket face aim to the installation hole ,put
on the flat washer, spring washer and screw bolt, screw
the nut from bottom to top.
2.Fasten the screw nut clockwise with provided wrench.
wrench
Installation Instruction( mounted on the light pole )
