For Machines Mfg. Since 8/11
Model SB1001 8K
™
Lathe
-21-
P R E P A R A T I O N
Test Run
After all preparation steps have been completed,
the machine and its safety features must be
tested to ensure correct operation. If you discover
a problem with the operation of the machine or
its safety components, stop the motor, disconnect
the machine from power, and do not operate it
further until you have resolved the problem.
A Troubleshooting section is provided, starting
on Page 57, to assist you with solutions if a
problem occurs or if the lathe does not function
as described in this section.
If you need additional help after reviewing the
troubleshooting section, or you are not confident
troubleshooting the machine on your own,
contact our Tech Support at (360) 734-1540.
To test run your machine:
1.
Make sure the master power switch
(see Figure 14) on the front of the machine
is turned
OFF
.
2.
Read and follow the safety instructions
at the beginning of the manual, take all
required safety precautions, and make sure
all previous preparation steps discussed
in this manual have been followed and
completed.
Figure 14. Master power switch location.
Master
Power
Switch
3.
Clear
away all tools and objects used during
assembly, lubrication, and preparation.
4.
Make sure that the chuck and jaws, if
installed, are secure (refer to Chuck
Installation on Page 25).
Note:
If a chuck is not installed on the lathe, you
do not need to install one for this test.
5.
Push the emergency STOP button on the
control panel (see
Figure 15).
6.
Turn the spindle speed dial all the way
counterclockwise to set the spindle to its
slowest speed for start-up.
7.
Move the spindle switch to the OFF (middle)
position.
8.
Make sure the end cover is closed, as shown
in Figure 16.
Figure 15. Control panel.
Spindle
Speed
Dial
Emergency
STOP
Button
Spindle
Switch
Tachometer
Display
Figure 16. End cover closed.
End
Cover
