-52-
For Machines Mfg. Since 8/11
Model SB1001 8K
™
Lathe
S E R V I C E
3-Jaw Chuck
Oil Type ...... Mobil Vactra 2 or ISO 68 Equivalent
Lubrication Device ................ Pump-Type Oil Gun
Oil Amount ............................................ As Needed
Lubrication Frequency ...................................Daily
Proper lubrication of the chuck ball oiler (see
Figure 86) is done with a pump-type oil gun
that has a plastic or rubberized cone tip. We do
not recommend using metal needle or lance tips
as they can push the ball too far into the oiler,
break the spring seat, and lodge the ball into the
oil galley.
Figure 86. Chuck ball oiler.
Ball
Oiler
Push the rubber or plastic tip of the oil can
nozzle against the ball oiler to create a hydraulic
seal, then pump the oil can once or twice. If you
see sludge and contaminants coming out of the
lubrication area, keep pumping the oil gun until
clean oil runs out. When finished, wipe away any
excess oil.
Use the chuck key to rotate the chuck scroll gear
several times to distribute the oil.
Bedways & Slides
Oil Type ...... Mobil Vactra 2 or ISO 68 Equivalent
Oil Amount ............................................ As Needed
Lubrication Frequency ...................................Daily
Move the carriage, cross slide, and compound
rest (see Figure 87) to reach all surfaces, and
pay special attention to the dovetail ways of
the slides. Apply a thin coat of oil to them with
a lightly-oiled shop rag to prevent rust and
corrosion, and to ensure smooth operation.
Figure 87. Bedway and slides.
Cross
Slide
Compound
Rest
Bedway
