Sorvall WX 100 Ultra, Инструкция по эксплуатации

Страница: 107 / 131

Maintenance
Service decontamination policy
Thermo Scientific WX Ultra Series 3-3
instruction manual contains specific guidance about cleaning and decontamination methods
appropriate for the product it describes.
Clean and decontaminate your centrifuge as follows:
a. Remove rotor from the rotor chamber.
b. Decontaminate door and rotor chamber using an appropriate method.
2. Complete and attach Decontamination Information Certificate (in the back of your rotor or
instrument manual) to the centrifuge before servicing or return to Thermo facility. If Certificate is
not available, attach a written statement verifying decontamination (what was the contaminant
and what decontamination method was used).
If the centrifuge must be returned to a Thermo facility:
1. Contact your Thermo representative to obtain a Return Service Order Number (RSO No.); be
prepared with the name and serial number of the centrifuge or rotor and the repairs required.
2. Send item(s) with the RSO No. clearly marked on the outside of packaging to the address obtained
from your Thermo representative.
If the centrifuge to be serviced does not have a Decontamination Information Certificate attached and,
in Thermo's opinion presents a potential radioactive or biological hazard, the Thermo representative
will not service the equipment until proper decontamination and certification is complete. If Thermo
receives a centrifuge at its Service facilities which, in its opinion, is a radioactive or biological hazard,
the sender will be contacted for instructions as to disposition of the equipment. Disposition costs will
be borne by the sender.
Decontamination Information Certificates are included with these instructions. Additional certificates
are available from the local Account Representative or Field Service Engineer. In the event these
certificates are not available, a written statement certifying that the unit has been properly
decontaminated and outlining the procedures used will be acceptable.
Note
United States federal regulations require that parts and instruments must be decontaminated
before being transported. Outside the United States, check local regulations.
Note
The Field Service Engineer will note on the Customer Service Repair Report if
decontamination was required and, if so, what the contaminant was and what procedure was used.
If no decontamination was required, it will be so stated.