48
TV channels cannot be changed.
,
The channel is hidden (page 41).
,
A timer recording started, which changed the
channels.
,
The Parental Lock is activated (page 40).
,
When the Favourite List is displayed, you can
select channels only from the Favourite List.
Press FAVOURITE to turn off the list, then press
PROG LIST and select the channel (page 19).
,
You can select channels only from the Favourite
List by pressing PROG +/–, once you use
Favourite List.
,
Two recordings are in progress.
The picture does not fill the screen.
,
Set “Aspect Ratio” in the “Video” setup to fit the
screen size of your TV (page 42).
There is no sound.
,
Re-connect all connecting cords securely.
,
The connecting cord is damaged.
,
The input source setting on the amplifier or the
connection to the amplifier is incorrect.
,
The recorder is in reverse play, fast-forward,
slow motion, or pause mode.
,
If the audio signal does not come through the
DIGITAL AUDIO OUT (OPTICAL or
COAXIAL) jacks, check the “Digital Output”
settings in “Audio” setup (page 43).
,
A scrambled channel is selected.
,
The sound is muted. Press MUTING.
Sound breaks up.
,
Signal strength is low.
,
Check the aerial installation.
,
If the DIGITAL AUDIO OUT jacks are used,
check “Digital Output” in Audio setup (page 43).
The recorder does not start playback from the
beginning.
,
Resume play was activated (page 33).
TV Pause does not work.
,
You are recording to the disk or the disk is full.
The channel cannot be changed from the
channel you are recording.
,
Set the TV’s input source to “TV.”
Nothing was recorded even though you set the
timer setting correctly.
,
There was a power failure during recording.
,
The recorder’s internal clock stopped due to a
power failure. Wait for the recorder to adjust
itself.
,
The channel was disabled after the timer
recording was set. See “Programme Hide” on
page 41.
,
Disconnect the mains lead from the mains, and
connect it again.
,
The programme contains copy protection signals
that restrict copying.
,
There is not enough disk space for the recording.
,
A scrambled channel is selected.
,
Two other programmes were being recorded at
the start of the Timer Recording.
Recording does not stop immediately after you
press
x
REC STOP.
,
It will take a few seconds for the recorder to input
disk data before recording can stop.
,
The recorder does not stop immediately if
x
REC STOP is pressed soon after a recording
started.
Recording does not stop after you press
x
.
,
Press
x
REC STOP.
Timer recording is not complete or did not start
from the beginning.
,
There was a power failure during recording. If
the power recovers when there is a timer
recording, the recorder resumes recording.
,
If manual recording was under way, the
recording was given priority over the timer
setting (see page 31).
Sound
Playback
Recording/Timer recording/
Erasing
