Sony STR-DN840, Руководство по эксплуатации

Страница: 110 / 140

110
US
Dolby Digital or DTS multi channel
sound is not reproduced.
• Check that the DVD, etc. you are
playing is recorded in Dolby Digital or
DTS format.
• When connecting the DVD player,
etc., to the digital input jacks of this
receiver, make sure the digital audio
output setting of the connected
equipment is available.
• Set “HDMI Audio Out” to “AMP” in
the HDMI Settings menu (page 94).
• You can enjoy High Bitrate Audio
(DTS-HD Master Audio, Dolby
TrueHD), DSD, and Multi Channel
Linear PCM only with an HDMI
connection.
The surround effect cannot be
obtained.
• Make sure you have selected the sound
field for movie or music (page 52).
• Sound fields do not function when
DTS-HD Master Audio, DTS-HD
High Resolution Audio or Dolby
TrueHD with sampling frequency of
more than 48 kHz are being received.
A test tone is not output from the
speakers.
• The speaker cords may not be
connected securely. Check to see if
they are connected securely and cannot
be disconnected by pulling on them
slightly.
• The speaker cords may have short-
circuit problem.
• Make sure that you are not using
PARTY STREAMING function
(page 68).
A test tone is output from a different
speaker than the speaker displayed on
the TV screen.
• The speaker pattern set up is incorrect.
Make sure that the speaker
connections and the speaker pattern
match correctly.
When the receiver is in standby mode,
there is no sound output from the TV.
• When the receiver enters into standby
mode, sound is from the last HDMI
equipment selection before you turned
off the receiver. If you are enjoying
other equipment, play the equipment
and perform the One-Touch Play
operation, or turn on the receiver to
select the HDMI equipment you want
to enjoy.
• Make sure “Pass Through” is set to
“ON” in the HDMI Settings menu if
you connect equipment not compatible
with the “BRAVIA” Sync to the
receiver (page 94).
There is a time gap between the audio
output and visual display.
• Check that the PARTY STREAMING
function is not being used. To close a
PARTY, press PARTY START/
CLOSE until “CLOSE PARTY”
appears. For details, see page 69.
The FM reception is poor.
• Use a 75-ohm coaxial cable (not
supplied) to connect the receiver to an
outdoor FM antennas (aerial) as shown
below.
Radio stations cannot be tuned in.
• Check that the antennas (aerials) are
connected securely. Adjust the
antennas (aerials) and connect an
external antenna (aerial), if necessary.
Tuner
Receiver
Outdoor FM antenna (aerial)