6.Command Specification
READ BUFFER
SONY AIT-5 drive SDX-1100V series Ver.1.0
6-70
6.15.
READ BUFFER 3Ch
Bit
Bite
7 6 5 4 3 2 1 0
0
Operation Code (3Ch)
1
Reserved Mode
2
Buffer ID
3
(MSB)
4
Buffer
Offset
5
(LSB)
6
(MSB)
7
Allocation
Length
8
(LSB)
9
Control
The READ BUFFER command is used in conjunction with WRITE BUFFER as a diagnostic function for testing the
data buffer and the SCSI bus integrity of the drive. A REWIND command will be sent to the drive after
WRITE/READ BUFFER diagnostic testing to return to normal operation.
The READ BUFFER command is executed only when there is no tape inserted in the drive or when the tape is
positioned at BOT except in Echo buffer mode. Otherwise, the drive will return a CHECK CONDITION status with
a Request Sense Key of ILLEGAL REQUEST.
Note:
Buffer Offset:
The Buffer Offset field contains the byte offset within the specified buffer from which data will be
transferred. The initiator will conform to the offset boundary requirements returned in the READ BUFFER
descriptor. If the target is unable to accept the specified buffer offset, it will return a CHECK CONDITION status,
will set the Sense Key to ILLEGAL REQUEST, and set the ASC to ILLEGAL FIELD IN CDB.
Allocation Length:
The Allocation Length specifies the maximum number of bytes that the initiator has allocated
for returned data. An Allocation Length of ZERO indicates that no data will be transferred. Any other value
indicates the maximum number of bytes that will be transferred. The drive terminates the DATA-IN phase when
Allocation Length bytes of data have been transferred or when all available data has been transferred to the
initiator, whichever is less. The Allocation Length must be greater than four (except in data only mode), else the
drive will return a CHECK CONDITION status with an ILLEGAL REQUEST sense key set.
Mode:
The drive supports the following values within this field. If any other value is set, the drive will terminate the
command with a CHECK CONDITION status and an ILLEGAL REQUEST sense key set.
Table 6-72: READ BUFFER Mode values
Mode Description
0000b
0010b
0011b
1010b
1011b
Combined Header and Data
Data
Descriptor
Echo Buffer
Echo Buffer Descriptor
Combined Header and Data (0000b) - Combined Header and Data Mode-in this mode, the drive returns a
four-byte header followed by the data bytes. The drive terminates the DATA-IN phase when Allocation Length
bytes of header plus data have been transferred or when the header and all available data have been transferred
to the initiator, whichever is less. The four-byte READ BUFFER header is followed by data bytes from the drive's
data buffer.
Содержание SDX-1100V Series
